Synthesis βΊ Sound
Two knobs hidden in every sound.
Every wiggle has two basic measurements. How fast it repeats decides the pitch. How tall each wiggle is decides the loudness.
On a synth those are controlled in different places. The oscillator section chooses pitch. The amp section chooses loudness β usually with an so it can change over the life of a note.
They're independent. You can play a quiet high note or a loud low one; the synth treats those two properties separately.
Think of it like β
Pitch is how fast you wave your hand; volume is how wide. Try waving fast and small, then slow and huge β same arm, two independent variables.
βΈ Why this matters
Signal flow β watch the dot
Init the synth. Play and hold a C3.
π§ A steady tone at one pitch, one loudness.
Slowly turn the oscillator pitch up an while held.
π§ Loudness doesn't change; only the perceived note moves.
Return to C3. Slowly pull the amp level down.
π§ Pitch doesn't change; only loudness drops.
Set velocity β amp. Play soft, then hard.
π§ Hard hits are louder, with the SAME pitch.
Test your knowledge
Based on Pitch vs Amplitude. Use what you just read β not general knowledge.
βΈ Two oscillators blend to one waveform. Detune fattens by making them slightly out of tune.