
The Mix βΊ Beatmatching
The three-band swap β the core DJ technique.
Every channel on the mixer has 3 EQ knobs: LOW (bass), MID (vocals/snare), HIGH (cymbals/air).
Turning a knob down (cut) reduces those frequencies on that deck. Turning up (boost) adds them.
Most mixes use cuts: kill the bass on Deck B while bringing it in, swap basses between the two tracks.
Think of it like β
EQ is like layering clothes. You don't wear two heavy coats β you take one off when you add the other.
βΈ Why this matters
Signal flow β watch the dot
Cue Deck B in headphones; full-cut its LOW EQ (knob fully counter-clockwise).
π§ Deck B has no bass β sounds thin in headphones.
Bring Deck B's fader up to full while Deck A plays through master.
π§ You hear Deck A's bass + Deck B's mids and highs layered cleanly.
On the next 16-bar phrase boundary, kill Deck A's LOW and restore Deck B's LOW in one motion.
π§ Bass has swapped β Deck B now drives the low end.
Over the next 8 bars, gradually lower Deck A's MID then HIGH to wash it out.
π§ Deck A fades cleanly without a level dip.
Pull Deck A's channel fader down, restore its EQs to 12 o'clock for next time.
π§ Mix complete; deck reset for reload.
Test your knowledge
Based on EQ Mixing. Use what you just read β not general knowledge.