
Setup & Culture βΊ Your First Session
Gain structure, connections and what to check before you play.
Booth setup is the routine you run from the moment you walk into the booth until your first track plays. Done right, it's invisible. Done wrong, you'll be debugging cables when your set starts.
The basic checklist is: (1) load your USB, (2) check master/booth volume and headphones, (3) test each channel with the master fader down, (4) take over from the previous DJ on a clean phrase, (5) only then turn your master up.
You always assume the EQ knobs, gain, filter, and effects on the mixer are in random positions from the previous DJ. Reset everything to neutral (12 o'clock / off) before bringing your first track in.
Think of it like β
Pre-flight check. Pilots don't trust the previous flight's switches β they reset and verify every one before takeoff.
βΈ Why this matters
Signal flow β watch the dot
Greet the previous DJ. Ask 'how long do you have?' so you know your takeover window.
π§ Their answer determines whether you have 2 minutes or 20 to set up. Plan accordingly.
Insert USB into an idle CDJ, load your first track, set the playhead on its first hot cue (downbeat after intro), keep it paused.
π§ The deck shows your waveform. You're armed but silent.
Press the channel's Cue button, set headphone volume by ear against the room volume.
π§ You hear your track at the volume you need to beatmatch. Master in the room is untouched.
Visually check every EQ knob (low/mid/high), filter, and colour FX on your channel β return any that aren't at 12 o'clock / off to neutral.
π§ Channel is now a clean slate.
Wait for a phrase boundary (8 or 16 bars) in the outgoing track. On the downbeat, press Play on your deck and bring the channel fader up while the previous DJ brings theirs down.
π§ Clean takeover. No level change in the master, no EQ collisions, no missed beat.
Test your knowledge
Based on The Booth Setup. Use what you just read β not general knowledge.